Anchor bolts come in several different configurations, such as 90-degree bent, headed, rods with threads on each end, or fully threaded rods to name a few. Anchor bolts can be made in many grades. shapes and sizes, however, there are two distinct categories of anchor bolts: post-installed anchors and cast-in-place anchors. Although both types essentially perform the same function, the configuration will differ depending on the application. The following information will lay out the differences between the two.
Cast-In-Place Anchors
Cast-in-place anchors are anchor bolts that are cast in wet concrete before the concrete sets. Normally the anchor bolt will be installed in the foundation, which is then filled with wet concrete, only leaving the projecting thread of the anchor bolt exposed. The most common configurations of a cast-in-place anchor are a headed anchor bolt, a 90-degree bent anchor, or a rod with threads on each end with the embedded end having an assembled nut and often an anchor plate to keep the rod from pulling out. Cast-in-place anchors are normally used when large embedment lengths and high tensile strengths are required for a given load.
Post-Installed Anchors
Post-installed anchors are anchor bolts that are installed after the concrete base has been set. A hole is drilled into the concrete and the anchor is then installed into the hole. There are two main types of post-installed anchors: mechanical expansion anchors (MEA) and adhesive anchors.
Mechanical expansion anchors are first placed into the pre-drilled hole. They then expand, bearing against the concrete surface. Wedge anchors are a common type of MEA. MEAs are easy to install, however they have a relatively low tensile strength and are not recommended for use in tension zones where concrete is likely to crack.
Adhesive anchors are anchor bolts that are placed in a pre-drilled hole, which contains an adhesive that dries and bonds to the anchor rod thread as well as the concrete. Adhesive anchors, also known as epoxy anchors, are capable of reaching high bond-stress values in relatively fast cure times. Adhesive anchors are fully threaded rods that can be supplied in many different grades and finishes and can be cut to any length required for a given application.
Is there a difference in pull-out strength between cast in place and post installed?
@Greg- We don’t have that data, since there are a lot of variables. Size, length, configuration, concrete type/density, distance to edge, etc. You might need to contact the ACI with your question and more details about your application.