A common question that we encounter has to do with what type of coupling nut should be used in conjunction with a particular grade of bolt or rod. Typically, a coupling nut would be specified as a grade of nut, as opposed to a grade of bolt. The ASTM grade of hex nut that is compatible with a particular grade of bolt or rod would typically be specified. For instance, per the F1554 specification, A194-2H or A563-DH heavy hex nuts are the recommended nuts to be used in conjunction with F1554-GR105 bolts or rods. Therefore, if you are coupling two F1554-GR105 rods together, the coupling nut would normally be called out as either A194-2H or A563-DH.
A typical, standard coupling nut length is three times the bolt or rod diameter. Some coupling nuts that are mass-produced are slightly shorter however. Longer coupling nuts can be manufactured as well.
Portland Bolt does not employ any engineers, so the frequent question of whether or not the coupling nut will “develop the strength of the rods,” should be directed toward an engineer.
For reference, see our table on coupling nut dimensions or our nut compatibility chart
Good morning, I am searching for coupler nuts to make an adjuster sleeve for a Studebaker. One side is 5/8″ RH NFT and the other is 11/16″ LH NFT. Finding the latter is my challenge. Any kind of help would be appreciated.
-John-
@John- Apologies, but we more get into couplers for structural applications, we don’t have any automotive type fasteners. Good luck.
What is the strength difference between a grade 2 and a grade 5 coupling nut?
@Clare- A JAE J995 grade 2 nut would be proofloaded to 90ksi, whereas a grade 5 nut would be proofloaded to 120ksi for sizes thru 1″, and 105ksi for sizes above 1″.
LOOKING FOR 1/2-13 X 13/4 GRADE 5 COUPLING NUT
One of our salespeople will contact you shortly regarding this.